tutorial Usanami

Usanami é HeadBand que imita orelhinhas de coelho,esta bombando do entre as Gyarus.

O tutorial esta em inglês,porque as imagens são auto-explicativas .(Google tradutor qualquer coisa ;)
DIY-Usanami

I made my pointy ears quite long. So cut 2 strips of fabric that is 9cm x 1m. Don't stress, 1.5cm seam allowance is included on both sides. So the actual headband will only be 6cm wide.

Now's time to twist the wires together. Your wires will need to join to make a long piece that is just a little over 2m because it needs to be folded in half to create the point. The wire is what will make those points stand up straight. If you are making a Usamimi that is quite short in height, then the wire should be optional. Wires can be found in craft shops.

After twisting like the photo above, use masking tape to seal the points for a smooth finish. Being poked by wires is more painful than you think.

Hooray! Smoothness. Then fold your long 2m wire in half like so:

Now it's time to sew the fabrics. Iron your fabric out first. Always iron! Always always always! I used a cotton floral fabric that I bought from Spotlight. I can't wait to make a summer dress from this. Anyways, measure out 1.5cm from both sides. Skip this step if you're using a sewing machine.

Place your fabric the right sides together (the side that you would want the world to see). So you're looking at the wrong side. Sew along the longer edges. However, leave a 10cm gap on one side. This is the place where you will feed through your wire. Look at the diagram if you're unsure. If you're hand sewing, try to use a backstitch with small stitch lengths so that your headband won't break so easily.

 Now sew away!

After you've done the sewing, its time to mark out the point on the ends. Draw any shape you like. Whatever floats your boat. Then sew along what you've drawn.

 Now it is time to flip your strip to the right side. This is where the 10cm gap is coming handy. Here's a tip: trim the fabric close to the point to prevent bulking. After you've flipped it then ironed it flat, it will look like this.

 Isn't it beautiful? Can you see the gap that I've left? Now feed your wire through. Make sure your pointed bit of the wire is pushed right into the point in the fabric. After feeding in one pointed side, twist the ends of your wires into a triangular point (remember to masking tape it) and feed into the other end of the fabric. Now use a needle and thread, tack the wire into place. It doesn't matter if you can see the thread because noone is going to scrutinise your headband upclose. Use an invisible thread if you're picky.

 See, you can hardly notice my dodgy sewing. Now repeat the tacking process every 3-5cm intervals on the pointed section and further apart on the straight section. This will help the wire to stay in place. Ladder stitch your opening close. Ladder stitch cannot be seen once it is pulled tight

 

Ladder stitch, go google it if you like

There you go, no visible stitching what so ever. Now that your headband is fully sealed and secured, I twisted the middle parts to make it thinner. This is completely optional and depends on your personal taste.

Now it is ready to wear!

Tirado de: gingerbreadmanne